Differences

This shows you the differences between two versions of the page.

--- firmware [2024/01/28 12:38] – torte
+++ firmware [2025/01/21 12:18] (current) – torte
@@ Line 1: / Line 1: @@
-===== Sovol SV06+ (mostly) =====
+{{page>redirect#this_wiki_has_moved}}
+https://torte71.github.io/InsideSovolKlipperScreen/firmware.html
+{{page>redirect#section}}
+----
+===== Sovol SV06+/SV07+ (mostly) =====
 ==== Firmware ====
-  * Where to download {{anchor:where_to_download}}
+{{anchor:where_to_download}}
-  * <code>
+=== Where to download ===
-klipper screen firmware location: (no permanent link given by Sovol)
+Klipper screen firmware location: (no permanent link given by Sovol)
+  * browse to: https://sovol3d.com
+  * menu: "3D Printer" -> "Sovol SV06 Plus"
+  * scroll down to "Select addons"
+  * select "Sovol Klipper Screen"
+  * scroll down to "Sovol SV06 Plus Klipper Screen Firmware"\\ ( currently points to https://drive.google.com/drive/folders/1vpKWQXOMGV58dYcx2wK9wJC0HJNqU8tg?usp=sharing )
+{{anchor:sdcard_not_accepted:}}
+=== SD-card not accepted ===
+  * Firmware file has to be renamed for each(!) update (*1)
+  * Use a card smaller than 32GB but bigger than 2GB (*2)
+  * Format only as "FAT32" (do NOT use "exFAT" or "NTFS")
+  * Set the sector size to 4096
+  * Have no other files or directories on that card
-- browse to: https://sovol3d.com
+*1: It only gets installed, if the filename differs from the one, which was used for the current installation.\\
-- menu: "3D Printer" -> "Sovol SV06 Plus"
+*2: Smaller than 2GB does not support 4096byte sectors, larger than 32GB does not support FAT32. If your card is bigger, create a partition which is smaller than 32GB.
-- scroll down to "Select addons"
-- select "Sovol Klipper Screen"
-- scroll down to "Sovol SV06 Plus Klipper Screen Firmware"
-  ( currently points to https://drive.google.com/drive/folders/1vpKWQXOMGV58dYcx2wK9wJC0HJNqU8tg?usp=sharing )
-</code>
-  * SD-card not accepted {{anchor:sdcard_not_accepted:}}
+Some info about SD-cards taken from [[https://forum.sovol3d.com/t/sv06-mainboard-brick-after-updating-sovol-firmware/862/68|here]].
-    * Firmware file has to be renamed for each(!) update (only gets installed, if the filename differs from the one, which was used for the current installation)